Comments on: MKS Base V1.4/Base V1.5/Gen V1.4 3D printer board Marlin firmware installation guide https://osoyoo.com/2016/06/30/mks-1-4-3d-printer-board-marlin-firmware-installation-guide/ Project Tutorial for Arduino compatible products Wed, 23 Sep 2020 23:29:42 +0000 hourly 1 https://wordpress.org/?v=6.1.1 By: Xander https://osoyoo.com/2016/06/30/mks-1-4-3d-printer-board-marlin-firmware-installation-guide/comment-page-2/#comment-1542 Wed, 23 Sep 2020 23:29:42 +0000 https://osoyoo.com/?p=1399#comment-1542 Hi I have MKS Base V1.4 board as per image above.

I am using Marlin 2.0.5.4 pins_MKS_BASE_14.h pins_MKS_BASE_COMMON.h pins_RAMPS.h
Have successfully connected LCD type “A10S A13 Display” (Came with CTC A10s 300) GFX with jog wheel (button), beeper & run out pin (Con1) to EXP1 on the Mainboard.

Having great trouble enabling SPI on EXP2 (for micro SD card interface)

Have tried:
#define SDSS 53
#define MISO_PIN 50
#define MOSI_PIN 51
#define SCK_PIN 52
#define AVR_MISO_PIN 50
#define AVR_SS_PIN 53
#define AVR_MOSI_PIN 51
#define AVR_SCK_PIN 52

With Kind regards
Xander

]]>
By: juandiegoalvarez https://osoyoo.com/2016/06/30/mks-1-4-3d-printer-board-marlin-firmware-installation-guide/comment-page-2/#comment-1008 Thu, 29 Nov 2018 00:20:31 +0000 https://osoyoo.com/?p=1399#comment-1008 Hello
I have a 3D printer with 2004 LCD
I follow the instructions above but when I program the atmega2560 the LCD won’t turn on
Some have an idea to solve it.
Note: I prove the LCD with other program and it’s turn on.

]]>
By: ultrareidar https://osoyoo.com/2016/06/30/mks-1-4-3d-printer-board-marlin-firmware-installation-guide/comment-page-2/#comment-643 Wed, 08 Nov 2017 13:59:01 +0000 https://osoyoo.com/?p=1399#comment-643 and filament sensor?

]]>
By: ultrareidar https://osoyoo.com/2016/06/30/mks-1-4-3d-printer-board-marlin-firmware-installation-guide/comment-page-2/#comment-642 Wed, 08 Nov 2017 10:40:16 +0000 https://osoyoo.com/?p=1399#comment-642 has anyone figure out the auto leveling?

]]>