Location: Home » Raspberry Pi プロジェクト » Tank Car for Raspberry Pi » Rasberry Pi Tank Robot Car Starter Kit Lesson 3: Line Follower

Rasberry Pi Tank Robot Car Starter Kit Lesson 3: Line Follower

Post Time: 2018-04-05 18:04:47 Category: Tank Car for Raspberry Pi

Rasberry Pi Tank Robot Car Starter Kit Lesson 3:Line follower

Previous_Lesson

Authorized Online Retailers

Buy from US Buy from UK Buy from DE Buy from IT Buy from FR Buy from ES

topObjective

In this lesson, we will use black/white tracking sensors to guide robot car to trace a black track in the white ground. If you have not completed installation in Lesson 1, please review Lesson 2.

Hardware Installation

Note: in lesson 1, 5 black/white tracking sensors have been installed and connected to Raspberry Pi to prepare for lesson 3.

Software Installation

Note:Please keep the raspberry Pi on power when using SSH to send command to Raspberry Pi terminal remotely.

Step 1:Download line-tracking sample code with following terminal command.

cd  osoyoo-robot/
wget --no-check-certificate   https://osoyoo.com/driver/lf-tank.tar.gz
Lesson3-step1

Note: Above commands will download sample code file to osoyoo-robot/lf directory
STEP2: Extract sample code file.
tar -zxvf lf-tank.tar.gz
cd lf

Lesson3-step2-1 Lesson3-step2-2

Step 3: Test Black/White Tracking sensors

There are 5 black/white tracking sensors in the forehead of the car. Each sensor has two LED lights . The red LED indicates power. The green LED indicates black/white. When black is detected, Green LED will turn off and a “1” will be sent to Raspberry Pi GPIO pin, otherwise LED will ON and a “0” will be sent.
* To make sensors working properly, you need use a screw driver to adjust the sensitivity screw on each sensor and make sure Green LED will ON when it is over White and Off when it is over Black.

Following python code and experiment will tell you if the sensors are installed correctly.
First, put a 2 cm black track on white ground, then put your car over the track and turn on battery.
Next, use SSH to connect your Raspberry Pi remotely from your PC(use Putty if you are using Windows), and type following terminal command:

sudo python test.py

Lesson3-step3

When your put the first sensor(from right) on the black track, the green LED will turn off and your will see Putty terminal window show 00001 as following:

Lesson3-step4-2

This means Raspberry Pi detected WHITE(0) from 4 sensors in the left and Black(1) from the right edge sensor. You can change the position of the black track from right to left sensors one by one and make the result change from 00001 to 00010,00100,01000,10000.If your result is not showed as above, you might need to double check if the sensor sensitivity and connection to the Pi is correct.

top

Testing line tracking

First, make a black track on white ground. The track can be round or curve , but the turning angle of each curve should not be too sharp. We suggest user use 2cm width black tape sticking on white ceramic tile and make a nice track.

Next put your car over the track and turn on the power switch on battery box.

Last, use SSH to connect Raspberry Pi through your PC and typing following commands:
cd ~/osoyoo-robot/lf
sudo python line_follow.py

Test

After above command is sent to raspberry Pi, your car will start moving along the black track automatically.
Previous_Lesson

DownLoad Url osoyoo.com

Leave a Reply


Address:
E-mail:
Tel: