Buy from US Buy from UK Buy from DE Buy from IT Buy from FR Buy from ES ここでご購入を！

Introduction

In this lesson, we will connect infrared receiver to NodeMCU, When infrared controller key is pressed, it will send an IR signal,then the receiver will catch these signals and send the IR code to the NodeMCU, the NodeMCU will publish these Messages to MQTT broker. If a MQTT client subscribe to the corresponding topic, it will get the messages from broker.

Preparation

Hardware:

Software:

Connection

Overhere,we use D2 as the digital input pin.

Upload Sketch

Connect the NodeMCU to computer via USB cable,open this sketch by using Arduino IDE(Version1.6.4+):

Edit the code to fit your own WiFi and MQTT settings as following operations:

1)Hotspot Configration:

const char* ssid = “your_hotspot_ssid”;

const char* password = “your_hotspot_password”;

Find above code line,put your own ssid and password on there.

2)MQTT  Server  Address Setting

const char* mqtt_server = “broker.mqtt-dashboard.com”;

You can use your own MQTT broker URL or IP address to set above mqtt_server value. You can also use some famous free MQTT server to test the project such as  “broker.mqtt-dashboard.com”,  “iot.eclipse.org” etc.

3)MQTT Client Settings

If your MQTT broker require clientID,username and password authentication,you need to change

if (client.connect(clientId.c_str()))

to

if (client.connect(clientId,userName,passWord)) //put your clientId/userName/passWord here

If not,just keep them as default.

After do that,choose the coresponding board type and port type as below,then upload the sketch to the NodeMCU.

MQTT Client Settings

About how to config the MQTT Client,check this link.

Topics Settings:

Running Result

Onece the upload done,if wifi hotspot ssid and password setting is ok and MQTT broker is connected, open the Serial Monitor,you will see following result:

The NodeMCU serial port will show the IP address and the connection satatus,then print the recevie value：

Once upload down,open the Serial Monitor and choose the right baudrate(115200 here),you will see the output as below:

Press different button on the infrared remote controller,you will see different receive value as follow,so you can use this way to know the infrared code for each button:

At the same time,you cam also open the MQTT client and click “Subscribe” button on the “OsoyooData” topic,you will see the message that published by NodeMCU: