In this circuit you will work with a potentiometer. You will learn how to use a potentiometer to control the brightness of an LED by reading a sensor and storing its 0–1023 value as a variable, then using it as a brightness level for the LED.
You will need the following parts:
A potentiometer is a resistance-based analog sensor that changes its internal resistance based on the rotation of its knob. The potentiometer has an internal voltage divider enabling you to read the change in voltage on the center pin with a microcontroller (i.e. micro:bit).
To hook up the potentiometer, attach the two outside pins to a supply voltage (3.3V in this circuit) and ground. It doesn’t matter which is connected where, as long as one is connected to power, and the other to ground. The center pin is then connected to an analog input pin so the micro:bit can measure the change in voltage. When you twist the knob, the sensor reading will change!
Ready to start hooking everything up? Check out the wiring diagram and hookup table below to see how everything is connected.
|Polarized Components||Pay special attention to the component’s markings indicating how to place it on the breadboard. Polarized components can only be connected to a circuit in one direction.|
|LED Module||Micro Bit Breakout|
|Potentiometer Module||Micro Bit Breakout|
Either copy and paste, or re-create the following code into your own MakeCode editor by clicking the open icon in the upper right-hand corner of the editor. You can also just download this example by clicking the download button in the lower right-hand corner of the code window.
Let’s take a look at the code blocks in this experiment.
If you are having a hard time viewing this code, click on the image above to get a better look!
A “variable” is a placeholder for values that may change in your code. You can create a variable using th
Make Variableoption underneath the Variables group. You can then name it, which then creates a block for your given variable.
To store a value inside of your newly created variable you use the
set to block. The
set to block allows you to select from a list of the variables that exist in your program and then add a value that you want to store or set that variables to.
In this program you are reading the voltage from the potentiometer which is 0 to 3.3 volts. The micro:bit reads that value as a 10 bit number which is a value range from 0 to 1023 using the
analog read block. The
analog read block is a value based block, meaning that you have to insert it into a block with a matching shape. We insert it into the
set toblock to store its value as a variable.
Just like the
analog write block the
analog write block deals with a range of values, but instead of reading a pin as an input the
analog write block outputs an analog value to a pin. We see this as a brightness range with this led, but it could be a tone from a buzzer, a motor speed, etc. We set our analog output to the variable we stored the potentiometer value in.
You should twist the potentiometer. You will notice that the LED will get brighter or dimmer based on the position of the potentiometer. If you turn the potentiometer all the way one direction it will be fully on and the other end will be fully off.
This is most likely due to a slightly dodgy connection with the potentiometer’s pins. This can usually be conquered by holding the potentiometer down or moving the potentiometer circuit somewhere else on your breadboard.
Make sure you haven’t accidentally connected the wiper (center pin), the resistive element in the potentiometer, to a wrong pin!
LEDs will only work in one direction. Double check your connections.
DownLoad Url osoyoo.com