Objective
In this lesson, we’ll introduce the installation and wire connections of the basic framework of the whole OSOYOO 2WD Robot Car Starter Kit.
Parts and Devices
Device
|
Picture
|
Qty.
|
Accessories
|
Car Chassis
|
![](https://osoyoo.com/wp-content/uploads/2017/09/亚克力底盘-1-300x300.jpg) |
1
|
|
|
![](https://osoyoo.com/wp-content/uploads/2017/09/电机-300x300.jpg) |
|
??? |
|
|
1 |
M3*12 Double Pass Copper Pillar x 4
M3*5 Screw x 8 |
|
![](https://osoyoo.com/wp-content/uploads/2017/09/轮子-2-300x300.jpg) |
|
|
Box for 18650 3.7V battery+
|
![](https://osoyoo.com/wp-content/uploads/2017/04/9-1-300x300.jpg) |
1 |
M3*10 Screw x 4
M3*10 Nut x 4 |
|
![](https://osoyoo.com/wp-content/uploads/2017/04/LACC200600-11-150x150.jpg) |
1 |
M3*6 Plastic Screw x 3
M3 Plastic Nut x 4
M3*5+6 Plastic Pillar x 4 |
OSOYOO Model-X Motor Driver Module
|
![](https://osoyoo.com/wp-content/uploads/2017/04/L298N-150x150.jpg) |
1 |
M3*6 Plastic Screw x 4
M3 Plastic Nut x 4
M3*5+6 Plastic Pillar x 4 |
UNO Sensor Expansion Board V5.0
|
![](https://osoyoo.com/wp-content/uploads/2017/09/扩展板-300x300.jpg) |
|
|
|
![](https://osoyoo.com/wp-content/uploads/2017/04/10-1-300x300.jpg) |
|
|
Jumper wires(male-male,male-female) |
![](https://osoyoo.com/wp-content/uploads/2017/04/wire3-300x80.jpg) |
some |
|
Installation
Remove the protective film from the chassis.
Please pay attention:
The chassis has front side and back side, please pay attention to the front side as the picture shows:
![](https://osoyoo.com/wp-content/uploads/2017/09/1-front-side-300x300.jpg)
1 Motors
Accessories:
Connect 2 motors on the chassis with screw M3*30 screws and nuts
![](https://osoyoo.com/wp-content/uploads/2017/09/2-front-side-300x300.jpg)
2 Universal Wheel and Wheels
Accessories:
- M3*12 Double Pass Copper Pillar x 4
- M3*5 Screw x 8
Install the wheel on the chassis with M3*12 Double Pass Copper Pillars and M3*5 Screws(please install the Copper Pillar on the chassis first), then install the two wheels into the motors.
![](https://osoyoo.com/wp-content/uploads/2017/09/3-back-side-300x300.jpg)
![](https://osoyoo.com/wp-content/uploads/2017/09/4-front-side-300x300.jpg)
3 Battery Box
Accessories:
- M3*10 Screw x 4
- M3*10 Nut x 4
Fixed the battery box on the surface of the chassis with the M3 screws and nuts