Decode Infrared Remote Controller with IR Receiver VS1838B

Note: ALL OSOYOO Products for Arduino are Third Party Board which is fully compatitable with Arduino

In this project, we will use IR receiver VS1838B to decode the signal sent by any Infrared Remote controller(i.e.remote controllers for TV, DVD, Satellite box, and the IR controller with this kit etc).

Step 1 – Download IRremote Library, and then import the library into Arduino IDE(in Arduino IDE->Sketch->Import Library->Add Library)

Step 2 – Connect board with IR Receiver
Connect Signal-Out pin(left),Ground pin(middle) and VCC pin(right),connect Signal out pin to D10,Grand to GND and VCC to 5V as per following graph:

Step 3 – Download irdemo.ino sketch file, load it into Arduin.

Step 4 – Point the Remote controller to the flat side of IR receiver(the side with “VS1838B” printing), then push any key on the remote controller. click the serial monitor in the upright corner of IDE window. The monitor Window will show the code of the key you just pushed. see following graph:

公式ストアは下記のリンクをクリック

Amazonですぐ購入！