Buy from US Buy from UK Buy from DE Buy from IT Buy from FR Buy from ES ここでご購入を！

Instruction

The Osoyoo NodeMCU comes pre-programmed with Lua interpretter, but you don’t have to use it! Instead, you can use the Arduino IDE which may be a great starting point for Arduino lovers to familiarize themselves with the technologies surrounding the IoT.Note that when you use the NodeMCU board with the Arduino IDE ,it will write directly to the firmware, erasing the NodeMCU firmware.So if you want to back to Lua SDK,use the “flasher” to re-install the firmware.

The NodeMCU programming can be as easy as in Arduino,the main difference is the distribution of pins in the nodemcu board.Following below operations and enjoy your first NodeMCU & IDE travel!

1.Connect your NodeMCU to the Computer

Use the USB cable to connect your NodeMCU to the computer,you will see the  blue onboard LED flicker when powered up, but they will not stay lit.

2.Install the COM/Serial port driver

In order to upload code to the ESP8266 and use the serial console, connect any data-capable micro USB cable to ESP8266 IOT Board and the other side to your computer’s USB port.

The new version NodeMCUv1.0 comes with the CP2102 serial chip,you can download and install the driver here.

The NodeMCUv0.9 comes with the CH340 serial chip,you can download and install the driver here.

3.Install the Arduino IDE 1.6.4 or greater

Download IDE from Arduino.cc (1.6.4 or greater) – don’t use 1.6.2! You can use your existing IDE if you have already installed it.

You can also try downloading the ready-to-go package from the ESP8266-project, if the proxy is giving you problems

4.Install the ESP8266 Board Package

Enter http://arduino.esp8266.com/stable/package_esp8266com_index.json into Additional Board Manager URLs field in the Arduino v1.6.4+ preferences (Open Arduino IDE–>File–>Perferences–>Settings).
reference

Enter the link and click “OK” to save your changes.

save link

Next, use the Board Manager to install the ESP8266 package

board manager

Enter the Boards Manager and find the board type as below:

install in the board manager

Scroll the Broads Manager screen down to the bottom, you will see  A module called “esp8266 by esp8266 Community” (see following picture), select the latest version and click “Install“.

installed

The ESP8266 package has benn installed successfully.

Note: You’d better close the Arduino IDE and restart it again.

5.Setup ESP8266 Support

When you’ve restarted, select NodeMCU 1.0  from the Tools->Board dropdown

tools

You also need to select a Port which matches your NodeMCU port
port
Above manual pictures are based on MacBook Arduino IDE, if you are using Windows PC, the manual might be a slight be different from MacBook computer.

Now just proceed as Arduino: Start your sketching!

Note: 115200 baud upload speed is a good place to start – later on you can try higher speeds but 115200 is a good safe place to start.