RepRap MKS BASE V1.4/ BASE1.5/GEN V1.4 Board 3D printer connection graph

• kingjam says:

  January 29, 2017 at 10:39 am

  Can you provide a pinout for the stepper motor connectors.

  Log in to Reply
  • kingjam says:

    January 29, 2017 at 10:40 am

    I forgot to say I have a MKS Base v1.5

    Log in to Reply
• bradley2548 says:

  February 7, 2017 at 12:41 pm

  I need the pinout for the MKS Base 1.5 For thermistors. I have downloaded your Firmware and Can’t get the second extruder to see the temp.

  Log in to Reply
• elaine says:

  February 7, 2017 at 7:41 pm

  Do you config the Z anix according to the instruction?

  Log in to Reply
• panadar says:

  June 27, 2017 at 8:09 am

  Have a question. If I wanted to attach a BL Touch auto bed leveling probe, what pins would i attach the probe to for the MK SBASE v1.5 board? Just got the is board and would like to attach a auto bed leveling probe to it. Thank you very much in advance.

  Log in to Reply
• Suusi M-B says:

  August 8, 2017 at 12:58 am

  How do you access the I2C bus on the MKS gen 1.4?

  Log in to Reply
• ultrafloon says:

  November 5, 2017 at 5:14 pm

  hello …. i have 1 MKS BASE 1.5 i need help for configure marlin for the tronxy xy-08n sensor for my anet a8 please ?

  Log in to Reply
• seaquest75 says:

  November 17, 2017 at 4:24 am

  HI, I’ve questions about the two extruders. Actually I’ve the MKS Base v1.4 powered with a 12VDC 20A Power supply. I’ve buy a second extruder and I’m concern about the power required and the actual power wires. There are already hot. Not at the point to melt, but there are hot.

  So I’ve connect a 100A shunt with a DC power meter and found that my actual board power used is really near the maximum of my power supply (18.5A±1A). I’m wondering, if the actual board connector will be tough enough to support 2 extruders because, I will replace my actual 20A for a 40A (480W) Power supply.

  Log in to Reply
• aldohoyt says:

  February 2, 2018 at 7:37 am

  How to connect endstops– The connectors on the MKS 1.5 board have 3 pins. The switches only have two pins. Which two pins on the connectors should be used?

  Log in to Reply