1) )Objective:
Use Mega2560 to get Latitude ,longitude and altitude from U-BLOX NEO-6M GPS module
2)Parts
1 x Mega2560 board
1 x U-BLOX NEO-6M GPS module
3) About U-BLOX NEO-6M GPS module
The module uses U-BLOX NEO-6M module.The module comes with high-performance ceramic antenna, which is equival of the integrated active antenna.Module comes with EEPROM. All configuration information can be stored in the EEPROM. A variety of configurations to meet your needs.The module also comes with a rechargeable backup battery (to support warm or warm start. after the main power supply power off, back-up battery power can maintain a half hour for GPS receiver data stored).
Features
Technical Parameters
Parameters | Value |
---|---|
Power Supply | 3V/5V |
Model | GPS-NEO-6M-001 |
Antenna | ceramic antenna |
Battery | rechargeable battery back-up |
Signal light | LED light |
Antenna size | 25*25mm |
Model size | 25.5mm*31.5mm |
Mounting Hole | 2mm |
The default baud rate | 9600 |
The default output | Compatible with NMEA0183 protocol |
Notice
4) Circuit connection and graph
mega2560 | GPS Module |
---|---|
5V | VCC |
GND | GND |
RX1(19) | TXD |
TX1 (18) | RXD |
4) Download sample code from following link :
5) Result:
Bring U-BLOX NEO-6M GPS module outdoor, open serial monitor window in Arduino IDE(upper right corner)
You will see following data information:
DownLoad Url osoyoo.com
You must be logged in to post a comment.
Hello, i buy U-BLOX NEO-6M GPS module. Can you provide CE Rohs certificate