Osoyoo IOT cloud starter kit for IntoRobot NUT ESP8266 WIFI chip

IntoRobot NUT is a cheap but powerful micro-controller board based on famous ESP8266MOD chip. If you are familiar with Arduino programing, you can learn NUT in no time.

NUT comes with access to the IntoRobot IOT Cloud, a free cloud service which has some great features for building connected projects, including over-the-air firmware updates, mobile APP remote control, and firmware development supported by web and local Arduino IDEs.

With this IOT cloud starter kit, you can make many interesting  projects and get some hands-on experience on Internet of Things. We have wrote step by step tutorial on each device in this kit.

Package includes:

• 1 x IntoRobot NUT WIFI IOT development board

  IntoRobot NUT Tutorial

• 1 x Micro USB cable

• 1 x Solderless Prototype Breadboard

• Jumper Wires

• LED (6 x Bright White, 6 x Red, 6 x Yellow, 6 x Green)

• 1 x DHT11

• 1 x Water level sensor

• 1 x 雨滴传感器

• 1 x 土壤湿度传感器

• 1 x 超声波传感器

• 3 x Potentiometer(10kilohm adjustable resistor)

• 10 x push buttons

• 1 x Temperature sensor [DS18B20]

• 1 x tilt sensor

• 1 x MQ2

• 1 x Piezo Buzzer

• 1 x 继电器

• Resistors (20 x 220ohm, 20 x 1Kohm, 20 x 10Kohm, 5 x 1Mohm)