Note: ALL OSOYOO Products for Arduino are Third Party Board which is fully compatitable with Arduino

Buy from US	Buy from UK	Buy from DE	Buy from IT	Buy from FR	Buy from ES	ここでご購入を！

Content

1. Introduction
2. Preparations
   • Hardware
   • Software
3. About the IR Track Sensor
4. Connection
5. Upload Sketch
6. Program Running Result

Introduction

The IR Track Sensor is essentially an IR LED and an IR detector. It works by transmitting a beam of IR light downward toward the surface. In this lesson, we will show you how the IR Track Sensor works and how to use it with the Osoyoo Uno board.

Preparations

Hardware

• OSOYOO Basic Board (Fully compatible with Arduino UNO rev.3) x 1
• OSOYOO Magic I/O Shield for Arduino x1
• OSOYOO IR Track Sensor x 1
• 3 pin PnP cable x 1
• USB Cable x 1
• PC x 1

Software

• Arduino IDE (version 1.6.4+)

About IR Track Sensor

Connection

First, please plug OSOYOO Magic I/O shield into OSOYOO Basic Board:

Then connect the OSOYOO IR tracking sensor to the port D2 of the Magic I/O shield with 3-pin PNP cables as below digram (please put the switch on tracking sensor to D):

Code Program

After above operations are completed, connect the OSOYOO Basic Board to your computer using the USB cable. The green power LED (labelled PWR) should go on.Open the Arduino IDE and choose corresponding board type and port type for you project. Then load up the following sketch onto your OSOYOO Basic Board.

const int trackingPin = 2; //the tracking module attach to pin 2
const int ledPin = 13; //pin13 built-in led
void setup()
{
  pinMode(trackingPin, INPUT); // set trackingPin as INPUT
  pinMode(ledPin, OUTPUT); //set ledPin as OUTPUT
}
void loop()
{
  boolean val = digitalRead(trackingPin); // read the value of tracking module
  if(val == HIGH) //if it is HiGH
  { 
    digitalWrite(ledPin, LOW); //turn off the led
  }
  else
  {
    digitalWrite(ledPin, HIGH); //turn on the led
  }
}

Running Result

A few seconds after the upload finishes, set it down on a piece of paper with a dark line (at least ½” wide). You may use a Sharpie Marker, electrical tape, or dark paint. When the module gets on a black line, it output high and the corresponding LED stays off; when it meets a white area, it outputs low and the LED lights up.

Note:

1.The black line should be wider than the IR track sensor.

2.The sensitivity of the infrared sensor is adjustable – you may adjust it by the potentiometer.