In this lesson, we will show you how to make use Internet to monitor remote Light Sensor status.
We will use Osoyoo Mega-IoT Shield to connect Light Sensor(photoresistor), LEDs and MEGA2560 MCU board. OSOYOO Advanced Board for Arduino MEGA2560 can work as a web server. Remote browser can access this web server to shows light sensor real time status.
First, please plug OSOYOO MEGA-IoT Extension Board into MEGA2560 board:
Then connect the modules with the OSOYOO MEGA-IoT Extension Board with four 3-pin PnP cables as below:
(Jumper Cap should connect ESP8266 RX with A8, TX with A9)
Green LED Module – D12
Red LED Module – D11
Buzzer Module – D5
Photoresistor Sensor – A0
Step 1 Install latest IDE (If you have IDE version after 1.1.16, please skip this step)
Download IDE from https://www.arduino.cc/en/software, then install the software.
Step 2 WifiEsp Library Installation (if you have installed WifiESP library, please skip this step)
OSOYOO MEGA-IoT extension TX/RX pin to OSOYOO Advanced Board for Arduino MEGA2560 A9/A8 pin by default. So in the sketch code, we need use Software Serial Port to communicate with ESP8266 (set A9 as TX and A8 as RX in softwareserial object).
To use this wifi shield in IDE, we need download WiFiEsp-master library from following link:
Open IDE, click Sketch – Include Library- Add .Zip library to load above zip files into IDE.
Step 3 After installing above library, please download the main code from following link, unzip it, you will see a folder called “smarthome-lesson12”:
Step 4 After above operations are completed, connect OSOYOO MEGA2560 Board to PC with USB cable.
Step 5 IDE: Choose corresponding board type and port type for you project .
Step 6 IDE: Click file – Open, then choose code “smarthome-lesson12.ino” in the folder, load up the sketch onto your OSOYOO Advanced Board for Arduino MEGA2560.
Note: In the sketch, find line 24，25 as following:
char ssid = "******"; // your network SSID (name) char pass = "******"; // your network password
please replace the ****** with your correct wifi SSID and password, otherwise your project can not connect to Internet.
After loading the sketch to OSOYOO Advanced Board for Arduino MEGA2560 , open the serial monitor in the upper-right corner of IDE, you will see following result:
From the serial monitor , you can see the IP address of your MEGA2560 board in the read circle (in above picture, 192.168.50.102).
Now use your hand to block all the light over the light sensor, Then use your browser to visit the website http://mega2560-ip-address (in above case, http://192.168.50.102), you will see following result:
Above result means there is no light signal is detected. The Red LED on the D13 pin of MEGA-IoT shield is off and Green LED is ON which shows the same result.
Now expose the light sensor to light source, You will see the Green LED on IoT shield will be off and Red LED will turn ON, buzzer will alarm.
Now check the web browser , after about 2 to 5 seconds, the browser will show following result.
DownLoad Url osoyoo.com