Connection:
L298N to Motors:
K1/K2 to right motors
K3/K4 to left motors

GP16(Physical#21) to IN1 right motor direction pin
GP17(Physical#22) to IN2 right motor direction pin
GP18(Physical#24) to IN3 left motor direction pin
GP19(Physical#25) to IN4 left motor direction pin
GP10(Physical#14) to ENA right motor PWM
GP9(Physical#12)  to ENB left motor PWM
GP13(Physical#17) to left tracking sensor
GP14(Physical#19) to right tracking sensor

GP# as per the light green pin icons in following picture:

Step 1) Install Arduino IDE
Visit https://www.arduino.cc/en/software and install the latest Arduino IDE software for your computer

Step 2) Install Arduino Mbed OS RP2040 board to support Pico:

Open Arduino IDE ->Tools ->Board Manager

In search bar, search pico , you will find a board name “Arduino Mbed OS RP2040 board “, Click Install button to install the latest version for this board into IDE.

Step 3) Install RP2040_PWM library
Download the RP2040_PWM.zip file from https://osoyoo.com/download/RP2040_PWM.zip

Then Open Arduino IDE-> click Sketch->Include Library->Add .Zip Library->upload the RP2040_PWM.zip  file to IDE

Step 4)Download and Run the Arduino Code:
Please download the code file from https://osoyoo.com/driver/pico_car/lesson2/picocar-lesson2.zip

Unzip the file and run the picocar-lesson2.ino sketch file through Arduino IDE, after you upload the code,  please put the car to ground, turn on the power, then put the car on to a tracking line, make sure the line is between the two tracking sensor, your car will follow the tracking line and move forward.