Buy from US Buy from UK Buy from DE Buy from IT Buy from FR Buy from ES Buy from JP

The OSOYOO building bricks is mechanically compatible with leading building bricks. In this lesson, we will use OSOYOO Bricks to build an elevator and use OSOYOO electronic sensor module blocks to control it. When you press the push button, the elevator will be up; and when release, the elevator will be down. (加一个旋转视频)


Before you build an elevator with blocks, please according to the Preparation before class 3:


Please follow this video to Building Blocks: (加搭建视频)

Connect push button to D2 port with 3pin PnP cable, Servo to D9 port as per following picture:

Note: In this kit, we use mblock as programming tool, if you want to learn more about mblock, please visit preparation before class 1:

Step 1) Download mBlock PC from, select the download file as per your computer OS type:

Step 2) Download OSOYOO_UNO.mext device file from

Step 3) Run the mBlock PC software by double click the lovely Panda icon. you will see mBlock UI as following picture. Please delete the default device CyberPi by click the cross in the red circle.

Step 4) Drag and Drop osoyoo_uno_mext file(downloaded in Step 2) to mBlock software as following:

Now you will see a new device firmware in mBlock, see following picture:

Now mBlock software and OSOYOO_UNO device firmware have been successfully installed in our PC!

Now we will show you how to use blocks to make our Oscillating Pedestal Fan into reality.
Step 1: Click Control, then Drag and drop Forever block to programming area as following:

Step 2: Click Events, add when Arduino Uno starts up block to the top:

Step 3: Click Control , drag if else block to forever loop,

Step 4: Click Sensor, Add Button Pressed blocks to if condition area, change Pin number to 2:

Step 5)
Click Action , then drag set Servo Pin blocks to if else block as following:

Now all the programming blocks have been completed! From above picture, the logic is pretty straightforward:

When Arduino is started, computer will enter a dead loop which will check the button status, when button is not pressed, the servo will stop at original position (in my servo 0 degree ) and elevator is in the ground , when button is pressed, the servo arm will rotate from 0 degree position to 180 degree position and the elevator is lifted to the air.

Step 6) Upload the program to Arduino

1) Please connect your Arduino board to your PC with USB cable firstly. Then click the Connect button in the bottom of the mBlock software, you will see a USB window pop up,
2) select Show all connectable device check box , then a device drop-down menu will show up,
3) select your Arduino port from device drop-down menu
4) click Connect button to connect your PC to Arduino

5)After you PC is connected to Arduino UNO board, please click Upload button in the bottom of your software, then the code will be uploaded to UNO board:

Now turn on the power switch in the Magic board, the Arduino will start to work and elevator is in the ground. Press the button on D2, your elevator will be lifted, when you release the the button, the elevator will go back to the ground. (加实景操作视频)