In this lesson, we will show you how to make use Internet to monitor remote sound sensor status.
We will use Osoyoo Mega-IoT Shield to connect sound Sensor, LEDs and MEGA2560 MCU board. Arduino MEGA2560 board can work as a web server. Remote browser can access this web server to shows sound sensor real time status.
OSOYOO MEGA2560 Board x 1
OSOYOO MEGA-IoT extension board x 1
USB Cable x 1
Red LED PnP module x 1
Green LED PnP module x 1
Sound Sensor PnP module x 1
3-pin PnP cable x 3
First, please plug OSOYOO MEGA-IoT Extension Board into MEGA2560 board:
Then connect the modules with the OSOYOO MEGA-IoT Extension Board with four 3-pin PnP cables as below:
(Jumper Cap should connect ESP8266 RX with A8, TX with A9):
Green LED Module – D12
Red LED Module – D11
Step 1 Install latest Arduino IDE (If you have Arduino IDE version after 1.1.16, please skip this step)
Download Arduino IDE from https://www.arduino.cc/en/Main/Software?setlang=en , then install the software.
Step2 WifiEsp Library Installation (if you have installed WifiESP library, please skip this step).
OSOYOO MEGA-IoT extension TX/RX pin to Arduino A9/A8 pin by default. So in Arduino sketch code, we need use Software Serial Port to communicate with ESP8266 (set A9 as TX and A8 as RX in softwareserial object).
To use this wifi shield in Arduino IDE, we need download WiFiEsp-master library from following link:
You need go to Arduino IDE ->Sketch ->Include Library ->Add ,Zip library to load above zip files into Arduino IDE.
Step 3 After installing above library, please download the main code from following link, unzip it, you will see a folder called “smarthome-lesson11”:
Step 4 After above operations are completed, connect OSOYOO MEGA2560 Board to PC with USB cable.
Step 5 Arduino IDE: Choose corresponding board type and port type for you project .
Step 6 Arduino IDE: Click file – Open, then choose code “smarthome-lesson10.ino” in the folder, load up the sketch onto your Arduino.
Note: In the sketch, find line 24，25 as following:
char ssid = "******"; // your network SSID (name) char pass = "******"; // your network password
please replace the ****** with your correct wifi SSID and password, otherwise your project can not connect to Internet.
After loading the sketch to Arduino, open the serial monitor in the upper-right corner of Arduino IDE, you will see following result:
From the serial monitor , you can see the IP address of your MEGA2560 board in the read circle (in above picture, 192.168.50.102).
Then use your browser to visit the website http://mega2560-ip-address (in above case, http://192.168.50.102), you will see following result:
Above result means there is no sound signal is detected. The Red LED on the D11 pin of MEGA-IoT shield is off and Green LED is ON which shows the same result.
Now let’s make some noise. We connect a buzzer pin to D5 slot. You will hear very big noise. Put the buzzer close to sound sensor. You will see the Green LED on IoT shield will be off and Red LED will turn ON.
Now check the web browser , after about 2 to 5 seconds, the browser will show following result.
DownLoad Url osoyoo.com