|Buy from USA||Buy from UK||Buy from DE||Buy from IT||Buy from FR||Buy from ES||Buy from JP|
|Buy from US||Buy from UK||Buy from DE||Buy from IT||Buy from FR||Buy from ES||Buy from JP|
In this tutorial, we will use Osoyoo Model-3 Robot Learning Kit to make a simple remote controlled smart car. Once the car installation is completed, we will use an Infrared Remote to control the car movements including go forward, go back, left turn and right turn.
|1||IR receiver||1||Click here to buy|
|2||IR remote controller||1||Click here to buy|
|3||Hex Screwdriver||1||Click here to buy|
|4||20pin 15cm Female to Female Cable||1||Click here to buy|
Step 1: Install the smart car basic frame work as per Lesson 1 . If you have already completed installation in Lesson 1 , just keep it as is.
Step 2: Add an IR receiver module onto the car.
Note: There are some different between two versions for OSOYOO motor shield(V1.0 and V1.1),
If you get OSOYOO motor shield V1.0, please install the IR receiver module with 2pcs M3 plastic screws, M3 plastic pillars and M3 plastic nuts as follow:
If you get the OSOYOO motor shield V1.1，please install the IR receiver module on OSOYOO motor shield V1.1 as following:
Step 3: If you get OSOYOO motor shield V1.0, please connect S-VCC-GND IR receiver with D12-5V-GND of OSOYOO motor shield V1.0, as the following photo (Remember : DO NOT remove any existing wires installed in Lesson 1 ).
Note: Please skip this step if you get OSOYOO motor shield V1.1 :
|Download Arduino IDE here:
|7 zip is a free zip
utility that un-zips zip files
|Download 7zip here for free
Step 1: Install latest Arduino IDE (If you have Arduino IDE version after 1.1.16, please skip this step)
Download Arduino IDE from https://www.arduino.cc/en/Main/Software?setlang=en , then install the software.
Step 2: Install IRremote library into Arduino IDE (If you have already installed IRremote library, please skip this step)
Download IRremote library from https://osoyoo.com/picture/2WD_Car_V2.0/code/IRremote.zip, then import the library into Arduino IDE(Open Arduino IDE-> click Sketch->Include Library->Add .Zip Library)
Step 3: Download Lesson 2 sample code and unzip the download zip file lesson2.zip, you will see a folder called lesson2.
Step 4: Connect UNO R3 board to PC with USB cable, Open Arduino IDE -> click file -> click Open -> choose code “lesson2.ino” in lesson2 folder, load the code into arduino.
Notice: Shut off your battery or Unplug your power adapter when upload sketch code to Arduino.
Step 5: Choose corresponding board and port for your project,upload the sketch to the board.
Some user found that this IR remote does not work. The reason might be the IR remote sends different button code which does not match our sample code. In order to solve this problem. Please take following steps:
Step A) Get the IR code of each button in your IR remote.
Copy code from following link:https://osoyoo.com/wp-content/uploads/samplecode/irdemo2.ino
upload above sketch into your Arduino and open the serial monitor in your upper-right corner.
Write down the IR code of your control buttons ◄ ► ▲ ▼ “OK” button,
DownLoad Url osoyoo.com